Fixing Damaged Roof Shingles
It’s time to replace it if your roof is more than 20 years old and most of the shingles are damaged or badly worn. If you’re serious about significantly improving the look of your home, head over to Jayhawk Roofing & Siding. But if your roof is basically sound and is at a relatively shallow pitch that you’re comfortable working on, you can probably handle most repairs yourself. Here, we’ll take you through the three most-common ones: replacing damaged shingles; gluing down a badly curled shingle; and repairing shingles that have cracked. Always make roof repairs on a warm, dry afternoon; the shingles will be more supple and less likely to crack. And never climb onto a roof that’s wet, icy or covered with morning dew.
If part of a shingle is missing, you’ll have to replace the whole thing. First see if you have any leftover shingles from the last time the roof was worked on (with any luck, the builder or the roofer who handled the job left some behind). If not, you’ll have to buy a bundle at a home center or lumberyard ($15 to $20 per square-100 sq. ft.-of standard three-tab shingles). Choose the closest one if you can’t find a perfect match.Replacing a damaged shingle requires a hammer, a flat pry bar, a utility knife and a handful of 11/4-in. roofing nails. Each shingle is initially secured with four nails; when the next shingle course above is installed, however, its nails also pass through the top edge of the shingles in the course below.
By sliding the pry bar under the shingle immediately above the damaged one and gently lifting it to free it from the sealer strip, begin removing the first row of nails. You’ll see the first row of nails beneath.Slip the pry bar under the damaged shingle and pry upward. Once the nail pops up about 1/4 in., remove the pry bar, press the shingle down and pull out the nail. Repeat this procedure for the remaining three nails. Then push the pry bar under the shingle directly above the damaged one and remove the second row of nails the same way. After yanking all eight nails, pull out the damaged shingle.
If the existing shingles are brittle, you may not be able to pry out the second row of nails without cracking a shingle. In that case, tear out the damaged shingle and cut V-notches in the replacement to fit around the four nails. Slide the new shingle up into place and secure it with four nails.
Fix Curled Corners
As asphalt shingles get older, their corners often begin to curl downward or upward. You can forestall the inevitable curling by gluing down the curled section if you notice a shingle starting to curl.Use a caulking gun to apply a dab of roofing sealant (about $4 per 10-oz. tube) under the corner. Weigh it down with a brick (right); leave the weight in place for at least 24 hours until the sealant dries. That’s all there is to it.
Repair Cracked Shingles
You don’t have to replace it-just repair it if a shingle is simply cracked or torn. By applying a thick bead of roofing sealant under the crack, start. Press the shingle down and apply a second bead of sealant on top of the crack. Then spread the sealant with a putty knife.
The best part of this fix is that no one has to know you made it. It’s easy to camouflage: Check the gutter for an accumulation of colored granules that have washed down the roof from the shingles. Then gather some into a small cup and sprinkle them over the sealant to mask the repair.A new roof is a pricey proposition. These simple repairs can keep your existing roof sound for years to come.